There is no single way to make aluminum foam. The route determines cell size, pore-size distribution, achievable part geometry, cost and how repeatable the final density is — so understanding the process helps a buyer ask better questions.

1. Melt foaming (direct foaming)

Aluminium or an aluminium alloy is melted and its viscosity is raised, commonly by adding calcium or ceramic particles. A blowing agent — typically titanium hydride (TiH2) or calcium carbonate (CaCO3) — is dispersed into the melt and decomposes, releasing gas. The melt expands into a closed-cell foam and is then cooled in a controlled way so that the cell structure solidifies before it drains or collapses. This is the workhorse route for large closed-cell blocks and boards because it is comparatively low cost and scalable. The challenge is holding cell size, density and skin quality uniform across a large casting.

2. Powder-metallurgy foaming (precursor route)

Aluminium powder is mixed with a small amount of blowing-agent powder, compacted and extruded or rolled into a dense, foamable precursor. When the precursor is heated, it expands into a closed-cell foam inside a mould. Because the gas source is distributed at the powder level, this route offers good control of cell structure and can produce near-net-shape parts and foam-core sandwich blanks. It carries the extra cost of powder and precursor preparation.

3. Infiltration / investment casting (open-cell)

A removable space-holder or sacrificial template is infiltrated with molten aluminium; after solidification the template is removed, leaving a connected open-cell network. Pore size and connectivity are set by the template, which gives good control but adds process steps. This is the standard family of routes for filters, heat exchangers and flow-through components.

4. Gas injection and continuous routes

Gas is injected into molten aluminium through a rotating impeller or nozzle, and the resulting foam is skimmed or continuously cast. These approaches aim at continuous production and lower cost; cell size tends to be larger and control of pore distribution is more difficult, so they are typically used where tight mechanical consistency is not the governing requirement.

5. Additive manufacturing and designed lattices

3D printing and other additive routes can produce periodic or graded cellular metal structures with pore geometry defined by a CAD file. They are excellent for research, prototypes and high-value components, but are slow and expensive for large architectural or infrastructure panels. Note that a printed lattice is a designed cellular structure rather than a stochastic foam.

What the buyer should ask

Ask whether density and cell size are controlled by process parameters or inspected batch by batch; what the density tolerance is; whether the surface skin is retained or machined off; and which test standard supports the quoted plateau stress. A supplier who can describe the route and its control points is usually also the one who can reproduce a batch.

Key takeaways

  • Melt foaming dominates large closed-cell boards; powder routes give better cell control.
  • Open-cell foam generally needs a template or infiltration step.
  • Additive routes suit prototypes, not bulk panels.
  • Process capability shows up as density and cell-size consistency in the batch report.