An absorption coefficient printed on a datasheet is a measurement of a build-up, not a property of the metal. Change the cavity behind the panel and you have changed the product.
What the cavity does
A rigid backing behind an absorber reflects sound. With an air gap between the absorber and the backing, the particle velocity maximum can be positioned inside the dissipative pore network at lower frequencies, shifting absorption towards the low–mid frequency range that matters for traffic noise. Increasing cavity depth generally moves the absorption peak downwards; a panel mounted directly on a hard surface behaves differently.
The variables that travel together
- Surface opening: perforation ratio, hole geometry, or mechanically opened pores
- Panel thickness and density: affect flow resistance through the structure
- Cavity depth: the distance to the rigid backing, and whether it is empty or filled
- Mounting and specimen area: part of the test geometry, especially in a reverberation room
- Frequency range: a single NRC-style number hides the shape of the curve
Method matters
ASTM C423 reverberation-room results (random incidence, large specimen) and ISO 10534-2 / ASTM E1050 impedance-tube results (normal incidence, small sample) are not interchangeable. A supplier quoting a high coefficient should also state the method, the mounting type and the cavity used.
Writing a comparable acoustic specification
Specify: the required absorption coefficient by octave or third-octave band; the test method and standard with year; the complete build-up (panel thickness, density, opening pattern, cavity depth, backing); specimen mounting; and the acceptance criterion. Then request the full measured curve from each supplier. This avoids the common situation of comparing two numbers that were never measured the same way.
From laboratory to the corridor
Even a correct laboratory result does not equal the insertion loss of an installed barrier, which also depends on barrier height, length, geometry, ground conditions and the source–receiver path. The acoustic consultant should translate the material data into a system prediction.
Key takeaways
- Absorption is a property of the whole build-up.
- Cavity depth shifts the absorption peak in frequency.
- Compare only data from the same method and mounting.
- Specify the full frequency curve, not one number.


