An energy absorber is specified backwards: start from the event, not from the material. The three inputs that determine the foam grade are the energy to be dissipated, the maximum force that may be transmitted and the distance available to crush.

The energy balance

The energy absorbed is approximately the area under the force–displacement curve. For a foam with a flat plateau, that is roughly plateau force × usable stroke, where the usable stroke ends at densification (commonly around 0.4–0.8 strain). A higher density raises the plateau force and the energy absorbed per unit volume, but also raises the peak force transmitted to whatever is being protected.

Selection sequence

  1. Define impact mass, velocity and thus kinetic energy.
  2. Set the maximum allowable deceleration / force on the protected object.
  3. Measure the available crush distance in the geometry.
  4. Choose plateau stress and thickness so that force × stroke covers the energy without exceeding the force limit.
  5. Select the density that produces that plateau stress, with a tolerance band.
  6. Verify with compression curves at the purchased density and impact tests at the relevant velocity.

Static vs dynamic

Quasi-static compression curves to ISO 13314 are essential for comparing grades, but high strain rates can change the measured response. Published comparisons report increases in energy absorption over a broad range depending on alloy, density and cell structure. Any safety-critical absorber therefore needs dynamic testing of the finished assembly; a static curve alone is not qualification.

Geometry and assembly effects

Edge constraints, face sheets, triggers that initiate stable progressive collapse, and the orientation of the foam all influence how the part actually crushes. A coupon test does not capture these. Test the assembled absorber with its real fixtures and load introduction.

Documentation

Request density and cell-size inspection data per batch, the full compression curve with specimen count and scatter, dynamic test results where relevant, and traceability linking parts to the batch. For protective or ballistic systems, certification belongs to the finished assembly and its own test programme, not to the raw foam.

Key takeaways

  • Specify from energy, allowable force and available stroke.
  • Density controls plateau force and absorbed energy together.
  • Dynamic testing is required for impact qualification.
  • Verify the assembled part, not just a coupon.